Skruepresse afvandingssystem

Vores skruepresseafvandingssystem, der er udviklet specielt til vores PE-filmvaskelinje, er en yderst effektiv metode til at udvinde fugt fra en materialestrøm. Faktisk bliver vores skruepresser ofte brugt i fødevareforarbejdning, papir- og papirmasseindustrier, spildevandsbehandling og meget mere. Dette holdbare stykke maskineri giver enestående fugtreduktion uden de væsentlige omkostninger (elektricitetsudgifter) ved drift af termiske varmeapparater.

Arbejdsprincip

At the core of our screw press dewatering system is a screw shaft with a progressively increasing diameter. The screw shaft is narrowest at the entry point where the plastic material is introduced via the vertical feeder. Surrounding the screw shaft is a thick-walled, uniform diameter outer tube lined with perforations for water drainage. The typical dewatering screw press for industrial recycling applications is 4-6 meters in length but can be adjusted according to your requirements.

As the wet plastic feed stock is introduced into the feeder, the screw shaft gradually rotates, advancing the plastic forward. As the screw shaft’s diameter increases, the plastic becomes increasingly compacted against the outer casing wall. The moisture from the plastic material is squeezed out and drains through the small perforations.

At the conclusion of the horizontal screw press, the screw shaft’s diameter is only slightly smaller than the inner diameter of the outer casing. It is through this narrow gap that the dried plastic material exits the screw press. A well-designed screw press will reduce moisture content to acceptable levels below 15%.

Yderligere billeder

Spørg nu

For at få de seneste priser og leveringstider, send os en besked ved at bruge formularen nedenfor.